Main page
 
Commander Skill Points
Constructions & Research

Units
Targeting Orders
Upgrades

Mining & Focus Effect
Special

Targeting

     Unlike in Minewars: Cincomm-9, where the target lists are set in stone, here in LMS you can change the targeting order of your units as needed to better control your armies and battle outcomes.

     Click "Target Orders" to bring up the table shown below in which you can change the targeting list of your units. As you can see, targeting is class based (ASU, mech, tank, etc.), similar to the system in Cincomm-9. Lower level units may be able to only target 1 class while higher level units may be able to target up to 3 different classes. So setting the targets is pretty straight forward: you simply select the class of targets under "Primary" for the first target class to be attacked, select the class of targets under "Secondary" for the second class, and so on.

Unit TypePrimarySecondaryTertiary
Anti-Air
Helicopter
Plane
Tank
LRMW
Mech

Targeting Orders Table


     After setting all targeting orders, click "Set Orders" to set the orders for all units. Be sure that you haven't made a mistake in setting the orders. You have a limited number of times you can set targeting orders per tick. Currently, the maximum is one time per tick, although there might be ways to increase this number.

     Once the targeting orders are set, they are instantly propogated to all of your units, whether they are in the home base or at a target section. This means that you can send your army to a base, attack the base, then adjust your targeting orders before your second attack if necessary.